Just a quick hello

This forum is for general and non-support discussion only. Sharing ideas? Networking? Looking for collaboration? This is the right place.
Post Reply
Posts: 19
Joined: Thu Nov 01, 2007 3:13 pm
Has thanked: 0
Been thanked: 0

Just a quick hello

Post by AJUK » Thu Nov 01, 2007 3:34 pm

Hi all,

I am new to the forums and thought I would say hi. Although I have owned a license for HD Pro for a while I have only just recently started using it in anger.

I am a structural engineer in the UK and I was using Vectorworks before but because it doesn't work very well on Leopard and I cannot justify upgrading to the new version, I dusted off HD and am now wishing I did it a lot earlier.

Be prepared for some questions as I get to grips with it. :)

Posts: 603
Joined: Tue Jul 06, 2004 10:52 pm
Location: California
Has thanked: 0
Been thanked: 0

Post by macitect » Thu Nov 01, 2007 3:46 pm

Welcome aboard!

I think you'll find it straightforward and easy enough, but for any of your questions you'll find that there are many on this board who are ready and willing to help. The tech support is really fantastic too!

Posts: 159
Joined: Fri Nov 10, 2006 4:39 pm
Location: Vancouver
Has thanked: 0
Been thanked: 0

Post by peatle » Thu Nov 01, 2007 10:20 pm

Response time from Ilexsoft Tech Support is incredibly quick so use it.

Second only to them is the response from Derek Tech Support ( Macitect )

Post Reply