Curve/Arc Tool Improvement

If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
Post Reply
siamak_etezadi
Posts: 1
Joined: Mon Dec 12, 2005 6:16 pm

Curve/Arc Tool Improvement

Post by siamak_etezadi »

Most of my work is related to Civil Engineering.

1- I would like to be able to draw an arc tangent to a line or an arc with given arc length/or angle and radius. Currently can draw curve tangent to two line as a fillet

2- Ability to Trim, Split,Break, Joint, and Extend arc as you do with line.


Thanks

User avatar
alexwhite
Posts: 266
Joined: Tue May 04, 2004 4:45 pm
Location: Indianapolis USA
Contact:

Post by alexwhite »

I believe you can accomplish No. 1 on your wishlist by changing the units or measurement in Preferences. You can then hard enter arc length, radius angle etc. Watch the dialog entry box in teh lower right corner and you will see the Angle, Length entry clues.

I second your No. 2 wish: breaking or tirmming an arc would be nice.
fat guy in a little coat

Post Reply