If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
1 post • Page 1 of 1
- Posts: 162
- Joined: Fri Dec 05, 2008 4:10 am
- Location: Mansfield, OHio
- Has thanked: 0
- Been thanked: 0
I would like to see the ability to have linetypes be scalable. That is, if i set the dash to a certain length, say 8", it will scale with the scale of the drawing and always be that length relative to the scale of the drawing. This would come in particularly handy in creating things such as a brick hatch. There could then be on running bond hatch created at full scale that could then be set to be scale dependent for the scale of the drawing.